This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
• Each unit is a dimmer, relay switch & 2-button transmitter depending on programming to control incandescent, fluorescent, inductive & magnetic LV loads
• Pre-programmed with 7 preset scenes P5-WS1D6 (WS1D-6)
B. PulseWorx® A
• The tool to use with a computer to configure UPB devices with UPStart™
RS232 Powerline Interface Configuration Software
• For a front-end controller to control UPB based units • Plugs into any standard 120VAC electrical outlet
• Connects to any available COM port via a DB9 serial cable (incl.)
P5-PIMR (PIM-R) C. PulseWorx®
Passive Phase Coupler
• Designed to enhance the communication reliability of UPB signals
• Proper design of a system will have one in each electrical panel with lighting control
B
• Provides a path for signal to cross to other phase in a typical split-phase (single-phase) 240VAC home
P5-PPC1 (PPC-1) D. PulseWorx®
120/240V Split Phase Repeater
• Designed for larger systems to guarantee certified communication signal strength
• Use in homes over 5,000 sq. ft or with more than 3 electrical panels
C
• Re-transmits signals from one phase to the other at full strength
• Wires phase to phase and to neutral P5-SPR1 (SPR-1)
E. PulseWorx® X-10 to UPB Bridge
• Enables any Security Panel or Controller that communicates X-10 to communicate UPB
• Plug and Play A1 On = Link 1 Activate P5-PW513 (PW513)
D
E
FOR ORDERS, CALL 800.233.6261 FOR SYSTEM SALES AND SUPPORT, CALL 800.234.7971 WWW.ADIGLOBAL.COM/US