6


UNDERSIZE INSERTS


Inserts of four pages or more which are intended to be smaller than the magazine in which they appear must also be pre-trimmed other than the head before collating, but because of the binding lap requirement, will appear stepped by 9mm from the centre of the insert. This will only be immediately apparent if the insert is placed in the centre of the magazine.


Example only:


5mm Head Trim


1/3 of full width (Binding Guard)


GATEFOLD INSERTS


5mm Head Trim


If these are to be the same trim size as that of the magazine, the usual head and foot trims must be catered for, but the foredge of the gatefold must be supplied 5mm short of the overall spine to foredge measurement. Special attention must also be paid if the magazine is bulking excessively as this allowance may not be sufficient.


Example only:


Trim size minus 5mm


Trim size


Trim size minus 8mm


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8