SAFETY IN THE PLANT
and soft tissue with fluid from the damaged hose being injected into the body. Depending on the entry pressure, the injected fluid can travel a significant distance from the initial site, resulting in more widespread tissue damage. The results of high pressure injection of a fluid such as oil can be deceptive, with the injury often being worse than it initially appears. Anyone injured, or with a suspected penetration injury, should therefore be referred immediately to the A&E department of a hospital and, if the injury is to the hand or lower arm, preferably a hospital with a hand trauma unit, as surgery is often required. The severity of the injury will depend on a number
of factors, including the type and amount of material injected, but hands are particularly vulnerable. In some cases where toxicity causes greater tissue damage, amputation may be required. Grease and oil may cause no reaction for the first two days, but then lead to extensive fibrosis and tissue damage and, because the body cannot break down the free oil that has entered, the treatment for this kind of injury is extensive. The more viscous the injected fluid, the greater the volume of tissue that will be affected, but even injected water carries risk of complications due to fungal or chemical contamination.
RUN-TO-FAILURE IS UNACCEPTABLE The clearest lesson we can learn from this is that a run-to-failure policy for hydraulic hoses is never acceptable. There are ways of predicting failure, either by calculating usage, using monitoring tools or employing visual checks. Most hoses will last for around a million cycles, so by analysing the run time of a piece of machinery, the average lifespan of the hose should be easily calculated. Monitoring systems, often based on RFID or infrared technology, offer a high degree of reliability and can account for any unpredictable wear and tear caused by misuse. Without monitoring technology, best practice is to combine usage calculations with visual checks - and
Hands are particularly vulnerable to fluid injection injuries, which can often require surgery
Visual checks work alongside usage calculations to keep hoses running safely for their whole lifecycle
it is essential that before any inspection is carried out, the hydraulic power pack should be shut off and de-pressurised. The symptoms of damage must be assessed by an individual who understands the cause and effect - for example, if any of the metal braid is visible or if any rubber is visible through the braid, the hose should be changed immediately. Other tell-tale signs of damage are blistering or swelling of the outer casing, which would indicate that the inner metal braid is damaged and oil is seeping through. Another cause of blistering could be incompatibility between the hydraulic fluid and the hose materials, again pointing to replacement. When replacing a hose, it is also important to
remember that hoses have a shelf life, so replacements should be checked for their ‘best before’ date and to make sure that they have been professionally swaged to ensure components have not been changed or replaced. Personnel most at risk of injury are, of course, those
who work around hydraulic pressure equipment but, in the event of a hose failure, it could simply be a case of someone being in the wrong place at the wrong time. Burst hoses pose considerable health and safety risks so a regular inspection policy is an essential safety requirement - as is an awareness of the implications should an accident occur. Brammer’s fluid power solutions team has extensive experience in the inspection, design and repair of hydraulic hose assemblies. n
Terry Davis is national technical manager at Brammer.
www.brammer.co.uk
REFERENCE: 1.
Fluid Injection Injury Emergency, published by the BFPA
www.engineerlive.com 37
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52