Laser Bed Alignment
zzlAP Laser Alignment Plate
UPC:656200075425
Laser Bed Alignment
1. Place the alignment plate in the top
left corner of the laser bed
2. Run this file
3. Measure the offset between the
box you lasered, and the box that was
already lasered.
4. Turn the laser off, then back on.
5. As soon as the word "Gravograph"
appears on the display, press and hold
the X button.
6. Select the option "ReAlign
Machine"
7. Select the option (ReAlign X Y)
8. Increase or decrease theX and Y values by the offset you measured
9. Press the check button, it will beep if the new values are accepted.
Troubleshooting:
If your machine will not allow the offset you need to enter, you’ll need to reset your fence.
In the package of tools that arrived with the machine, there will be an
allen wrench that will fit the screws along the rulers on the X and Y axis.
Move the rulers as far in as possible. Run your red light along each
axis to ensure the rulers are secured straight.
69
Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62  |  Page 63  |  Page 64  |  Page 65  |  Page 66  |  Page 67  |  Page 68  |  Page 69