CURTAIN WALLING


Aluminium substructure with horizontal support rails This support method is popular where ArGeTon®


is to be installed on to a unitised or curtain wall system


where the span of the vertical sections may be at extended centres. It may also be used where greater than normal projections from the structural wall are desired.


The substructure consists of vertical angle section support profiles fixed to the building by wall brackets. Horizontal aluminium support profiles are fixed onto the vertical support angle substructure. The spacing is determined by the selected height format of the ArGeTon®


tiles, which are fastened to the horizontal support profiles using special clamps. The maximum span of the horizontal profiles is 1.25m. Upper clip for ArGeTon® tile Lower clip for ArGeTon® tile


34


20 31 20


Centre clip for ArGeTon®


tile


Horizontal support rail


31


a20 25 Type I Type II


25


Aluminium joint profile for ArGeTon®


tile


Aluminium joint edge profile 48 4


Aluminium groove joint


60


60


29,5


50


Aluminium corner profiles for ArGeTon®


Square Box 43


tile


Open Cruciform 43


Half Round 43


Corner Blade


All figures in mm.


20 21


39 40 3


40


20


40


3


20 45


48


35 40 3


20


43


62


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24