23 Model Specification
The following Model specification details the standard/basic components and installation method for Unifold®. To customise your specification please select components as required from the accessories listing
Unifold® Gutter Lining System as manufactured by Ampteam Ltd., Units 5/6, Charlotte Street, Dudley, West Midlands DY1 1TD
Telephone No: 01384 252777 Fax No: 01384 252888
COMPRISING: An E.P.D.M Synthetic Rubber Membrane 1.14mm thick permanently factory bonded to 0.7mm galvanized steel sheet.
To include necessary bends and hinge(s) to provide maximum ease of installation.
Gutter lining sections provided in standard 2800mm lengths, fixed with butt straps provided and fully sealed in accordance with manufacturers instructions.
OUTLETS:
Patch type - supplied loose and cold vulcanised in position fully in accordance with manufacturers instructions.
STOPENDS: Supplied loose, fixed and fully sealed in accordance with manufacturers instructions.
Installation Procedure
1. Clean and reasonably dry the existing gutter(s) 2. Lay sole board ( Extruded Polystyrene or similar approved ) between and not over, existing gutter joints. (Thickness to suit height of bolt/nut/stud intrusions)
3. Install Unifold® stop-end at commencement of run and lay Unifold® gutter lining system fully in accordance with manufacturers instructions. Note: Sole board to be installed together with the Unifold® and at a similar pace.
4. Determine position of existing outlets as lining progresses, cut hole in Unifold® 5mm- 10mm larger in diameter than existing and fit system outlets fully in accordance with manufacturers instructions.
5. Cold vulcanize Sureseal Pressure Sensitive membrane flashings, 150mm wide and to the complete girth of the Unifold®, over each joint area, fully in accordance with manufacturers instructions.
6. Provide system Tie-off kits ( 1 no per 50 metres ) as provided by Ampteam Ltd, to be used for over-night weathering of incomplete runs and as emergency measures to prevent storm water penetrating the Unifold® and existing gutter cavity.
7. Following completion and final inspection provide Unifold® 20 year guarantee. The UNIFOLD® Solution
01384 252777 Phone us
unifold@ampteam.co.uk Click on email
www.gutterliners.com Click on website
UNIFOLD® gutter lining system Model Specification
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28