3700
ENGINE SPECS Shibaura 36 HP
Type Liquid-cooled, inline, 3-cylinder, normally aspirated industrial diesel engine Starter 12-volt (1.2 kw), solenoid shift positive engagement Charging System 12-volt, 40-amp alternator Oil Filter Spin-on engine oil filter 6.3 Qt (6.0 l) oil capacity Fuel Capacity 13 US Gal (49.2 L) Fuel Filter Heavy-duty, spin-on fuel filter, with sediment bowl Injection System Bosch in-line, indirect injection
Air Filter Heavy-duty air filter with safety filter for maximum protection, dry, dual-element Cooling Liquid cooled. Direct-driven, mechanical cooling fan Cooling Capacity 3700 5.6 qt (5.4 L) Governor Mechanical governor with 2700 RPM high idle speed PTO Independent type PTO. PTO speed 2209 RPM PTO Clutch Wet multi-disc manual
TRACTION DRIVE SYSTEM Type Auto 4WD or Full time 4WD Hydrostatic transmission driving, two-speed gear axle Filter 35 micron suction
Ground Speed Forward Low: 0-6 mph (0–9.5kph) High: 0-15 mph (0–24kph) Reverse Low: 0-4mph (0–6.5kph) High: 0-9mph (0–14.5kph)
Steering Hydrostatic power. Tilt & telescoping steering wheel
Speed Control 2 pedals forward & reverse. 2 range hydrostatic transmission, Cruise control Brakes Wet disc (Single pedal control)
Tyres Front Drive 24 x 12 – 12, turf tread, Rear Drive 20 x 8 – 10
Hydraulic Capacity 8.5 gal (32 L) Weight (Power unit) 1653 lbs (750 Kg)
SPECS GENERAL INFORMATION
Safety Features Operator presence system connected to seat, traction pedals and park brake switch. Hand-operated parking brake. Two-post foldable ROPS. Headlight Standard
Seat Suspension: Moulded-vinyl, adjustable seat with armrests. Fore and aft adjustment, suspension adjustment Deck Lift Hydraulic w/adjustable weight transfer
Controls Hand-operated throttle, ignition switch, L-N-H & AWD Lock, parking brake, hydraulic lift Cup Holder Single cup holder
Indicators Hour meter, temp gauge, oil pressure light, charge light, glow plug light, audible alarm for high engine temperature and low oil pressure, air filter monitor, fuel gauge
DIMENSIONS
Height: 53 in (1300 mm) ROPS folded down 77 in (1750 mm) ROPS up
DECKS
72” XR-7™ Side-Discharge or 72” Rear-Discharge Decks Deck Lift Raise and lower deck from driver’s seat with simple hydraulic-operated deck lift.
Construction Welded steel. Solid 1.5 in x .50 in (38 mm x 12.5 mm) steel bars reinforce impact areas on trim edges. Reinforcements welded onto spindle mount areas. Steel deck housing is 5.5 in (140 mm) deep to provide room for high-capacity mowing.
Cutting Heights Height adjustment in .25 in increments from 2 in to 6 in (50 mm to 150 mm)
Mowing Blades Heavy-duty, heat-treated, high-lift steel Fusion™ blades. Fusion blades feature an exclusive electro-fusion technology that creates an ultra-hard layer at the blade’s cutting edge, the blade remains sharp and continues to give a clean cut far longer than any blade on the market. 72 in: 24.50 in x 2.50 in x .230 in flat blade, high sail
Blade Tip Speed 72 in: 18,964 fpm Blade Drive V-belt drive to all three spindles. Spring tension idler pulleys.
THE HUSTLER EXPERIENCE. Top View Deck
Spindles Machine ductile housing, 1 in (25.4 mm) diameter high carbon steel shafts and sealed ball bearings.
Discharge Chute Moulded Rubber: Over-center design allows for chute to be folded up for improved trailering or to pass thru gates, etc.
Width of Cut 72 in: 72 in (1830 mm) Trim Capacity 72 in XR-7: 15.5 in (390 mm) (left side)
Specifi cations subject to change without notice. Go to
www.plpgolfandturf.com.au for most current specifi cations. 19 19
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28