Shows lineal germination of Aberroyal and filling in of groove lines after 8 days


examples of successful early April and, in some cases, March germination of bents, and clients who swear by these early sowing methods.


The same rule can apply to ‘how late can I sow?’. This is best achieved with one eye on the weather rather than pre- planning an October sowing. The last two Octobers have been great, but followed by terrible Novembers. There has been a trend recently of courses having their renovations delayed or, in some cases, called off due to the improved playing conditions in autumn, which is not helpful. I have seen successful October sowings, but September would be the latest I would recommend.


3. Which cultivars should I choose?


This topic has been most fascinating in recent years. I may have been blinkered by the sheer numbers of parkland, heathland and hillside courses I deal with in the North West, Midlands, West Yorkshire and North Wales, but this does reflect the greater percentage of British golf courses. First and foremost, I will say that I am a big fan of fescues in greens, they are the traditional and desired species that provide the least resistant surface for ball roll, and are slightly more disease tolerant than traditional browntops. But, so many of the courses I deal with cannot sustain fescue growth. This is down to a number of factors, most importantly height of cut. Realistically, 5mm is as low as you technically and biologically should cut in order to colonise fescues. I have seen it achieved at 4mm in special circumstances, but definitely no lower (to prune a tree you trim the branches ... you don’t cut it at the stump!). General wear, foot traffic and compaction are also contributory factors to the decline of fescues. Many courses have too many rounds of golf for the very fine, hence weaker fescues to establish and repair.


Another culprit is the weather.


Traditional clay push up greens, with poor drainage and low light levels, have suffered tremendously from three years of constant rain and, simply, the fescues die out if their roots are too wet and meadow grass invades.


This is why I have found a massive


surge in bentgrass popularity, whether it is our velvet bents (Agrostis canina) Avalon


AberRoyal colonising amongst a traditional greens makeup, note very fine leaves and denseness. Second year of overseeding


or Vesper (this could be a whole new article!) or our very popular native browntop, AberRoyal. More and more greenkeepers are veering toward a bentgrass dominated sward. There is still definitely scope for fescue application, especially early on, to repair winter scarring and in the traditional 80/20 mix for general repair work but, with a long term species improvement programme in mind, I believe that bentgrass will achieve this a lot quicker, bearing in mind the obstructions we find on modern golf courses (natural and manmade). Browntop or velvet bentgrass, especially newly bred varieties, are more likely to compete against annual meadow grass and form colonies with regular overseeding much quicker and more successfully than fescues. Disease resistance, leaf fineness and colour should also be a factor in your decision. A very recent topic of discussion with some of my clients has been a reversal of the nursery plant technique, and a longer term goal of reintroducing fescues back into a predominantly browntop sward. This can be achievable once the annual meadow grass is the lesser of the present species.


4. How should I apply the seed?


This is really a double question - there is the ‘best way’, and then there is the ‘best way you can afford’ to overseed. Obviously, there are fantastic machines that you can wind down to 2gms per m2 and to 2mm depth, but these are very expensive. Whichever method you choose, the most important issues are good seed/soil contact, correct depth (for best results, browntops and fescues should be sown separately and at different depths - fescues deeper) and a rootzone for establishing seedlings. This can be achieved with a number of methods. My favourite is lineal grooves (from a disc seeder rather than scarification) but brushing into holes will be successful too, as long as there is not too much disruption to the putting surface and established desired plants. I have plenty of clients who sarrel roll,


drop-spread the seed, drag the seed in then lightly topdress - job done with effective results. There are still a few ‘chicken feeders’ out there too! Advents, like growth regulators, as a


preseed assistant are fantastic too. If a shorter than desired height of cut


has been thrust upon you, then topdressing immature seedlings is a great way to minimise damage by early mowing.


Thatch levels will also throw up debate. Obviously, if there are underlying scientific reasons why overseeding will not be successful, then your agronomist is the best person to advise you on this. But, if you do have excessive thatch - and I emphasise excessive - then, whilst you are hopefully undertaking an extensive aeration programme, there is no crime in applying seed to the newly constructed holes (better than annual meadow grass invading).


This then leads on to the next statement;


5. I have no trouble with germination but my seedlings never survive.


This problem can be attributed to many factors: excessive thatch, disease, lack of/too much water, soil and air temperatures - all reversible or avoidable. Even the most experienced


greenkeepers I deal with are continually baffled by this - you do everything by the book and still the new plants struggle. Like I mentioned earlier, there are now a lot of new products and methods to assist with this. BSH’s angle is in the breeding - choosing a newly bred, native species, with quick adaptation to the climate, with all the modern attributes and requirements bred into it, has certainly curbed this issue for many greenkeepers. The new seedling shoots need some form of loamy soil to root into. This is why just generally ‘scattering’ the seed on the surface or into a thatch layer has limited success. Any form of surface breach, along with topdressing, will create the perfect environment, especially to avoid any thatch layer. Irrigation is key too. Obviously, with the onset of ‘stressing’ of undesired species, many greenkeepers are loath to water too much - another argument for spring seeding when there is more moisture about.


In conclusion, for every concern you may have, there is an answer for it. Speak to other greenkeepers, talk to the reps (we can be useful sometimes!) and, more importantly, have confidence in what you’re doing. Involve the committee, if necessary. We are always available to speak to them, if needs be ... and never be afraid to ask questions.


137


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62  |  Page 63  |  Page 64  |  Page 65  |  Page 66  |  Page 67  |  Page 68  |  Page 69  |  Page 70  |  Page 71  |  Page 72  |  Page 73  |  Page 74  |  Page 75  |  Page 76  |  Page 77  |  Page 78  |  Page 79  |  Page 80  |  Page 81  |  Page 82  |  Page 83  |  Page 84  |  Page 85  |  Page 86  |  Page 87  |  Page 88  |  Page 89  |  Page 90  |  Page 91  |  Page 92  |  Page 93  |  Page 94  |  Page 95  |  Page 96  |  Page 97  |  Page 98  |  Page 99  |  Page 100  |  Page 101  |  Page 102  |  Page 103  |  Page 104  |  Page 105  |  Page 106  |  Page 107  |  Page 108  |  Page 109  |  Page 110  |  Page 111  |  Page 112  |  Page 113  |  Page 114  |  Page 115  |  Page 116  |  Page 117  |  Page 118  |  Page 119  |  Page 120  |  Page 121  |  Page 122  |  Page 123  |  Page 124  |  Page 125  |  Page 126  |  Page 127  |  Page 128  |  Page 129  |  Page 130  |  Page 131  |  Page 132  |  Page 133  |  Page 134  |  Page 135  |  Page 136  |  Page 137  |  Page 138  |  Page 139  |  Page 140  |  Page 141  |  Page 142  |  Page 143  |  Page 144  |  Page 145  |  Page 146  |  Page 147  |  Page 148  |  Page 149  |  Page 150  |  Page 151  |  Page 152  |  Page 153  |  Page 154  |  Page 155  |  Page 156