Constant Color System
CONSTANT COLOR SYSTEM:
PORT ASSEMBLY INSTRUCTIONS (CONT’D)
F. Heat up hot knife (PN FS-118 or FS-163). Once hot knife is up to temperature, apply firm downward pressure on the fibers with the blade touching the insert at a slight angle (Fig 6). DO
NOT SAW BACK AND FORTH. Allow the heat of the
knife to slowly trim the fibers. Ease the pressure off as the knife starts to complete the cut. Turn the hot knife off and allow it to cool in a safe place.
G. Line up hole on insert with hole on the port and fully seat the insert on the port (Fig. 7).
7. ALIGN HOLES AND INSERT TIP FULLY
H. NOTE: Avoid touching the flat surfaces of the CC Rod as fingerprints will reduce light performance.
Slide the constant color rod inside the insert until the end is flush with the end of the tip (Fig. 8). Use the set screw to lock the constant color rod and tip in place (Fig. 9). DO NOT OVER TIGHTEN! Set screw should be just tight enough to keep the constant color rod and port tip in place.
I. Screw port assembly onto compression fitting until fully seated (Fig. 10)
6678 Owens Drive Suite 105 • Pleasanton, CA 94588 • 888.704.2276 •
www.fiberstars.com
39
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80