TRANSPORTING UNITS CE MARKING
When transporting any Bowens units, ensure that all All Bowens products are equipment uses radio frequency energy and, if not
equipment is carefully packed into appropriate bags certified by the CE mark. The installed and used in accordance with the
and/or hard shell cases. Make sure all items are CE certified mark is a instructions, may cause interference to radio
securely placed inside the appropriate baggage to declaration of conformity to communications. However, there is no guarantee
protected from any knocks. the required EEC directives that interference will not occur in a particular
89/336/EEC ‘Electromagnetic installation. If this equipment does cause harmful
When transporting flash units make sure to fully Compatibility’ and 73/23/EEC interference to radio or television reception, which
discharge flash power before packing. A quick way ‘Low Voltage Directive’. can be determined by turning the equipment off and
to ensure a unit is discharged is to turn the unit on, on, the user is encouraged to try to correct the
wait for it to charge to 100% and then open flash the interference by one or more of the following
unit using the ‘test’ button, then quickly turn off FCC CLASS B COMPLIANCE STATEMENT measures:
before the unit has recharged.
• Reorient or relocate the receiving antenna.
Flash units can become very hot after use. Always This device complies with Part 15 of the FCC Rules. • Increase the separation between the equipment
wait a minimum of 30 minutes before packing to Operation is subject to the following two conditions: and receiver.
allow units to cool sufficiently. • Connect the equipment into an outlet on a
• This device may not cause harmful circuit different from that to which the receiver is
If any unit is dropped and/or knocked during interference. connected.
transport, always have the unit checked by an • This device must accept any interference • Consult the dealer or an experienced radio/TV
authorised Bowens service/repair centre before received, including interference that may technician for help.
using. cause undesired operation.
Notice: Shielded interface cable must be used in
Warning: This equipment has been tested and found order to comply with emission limits.
to comply with the limits for a Class B digital device, Notice: Changes or modification not expressly
pursuant to Part 15 of the FCC Rules. These limits approved by the party responsible for compliance
are designed to provide reasonable protection. This could void the user’s authority to operate the
equipment.
bowens.co.uk
- 8 -
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16